Machine Maintenance 3-17
Removing the Memory Modules 0
1. Perform the “Removing the Back Cover” procedure described on page 3-12.
2. Push out the latches on both sides of the memory slot until the module tilts upward.
Figure 3-18. Memory Module Latches
3. Remove the memory module from the slot.
Figure 3-19. Memory Modules
A circuit board that is > 10cm
2
has been highlighted with a yellow rectangle in
Figure 3-19. Follow the local regulations for disposing this type of circuit board.
4. Repeat Steps 2 & 3 to remove the remaining memory module.
To Next Page
Loading...
