3-56 Machine Maintenance
Replacing the LCD Bezel 0
1. Place the bezel on top the LCD panel and then press the bezel on all sides until it snaps
into place.
Make sure that the LCD, webcam, microphone, and antenna cables are properly routed
on the hinge sides and there is no gap between the bezel and the LCD cover.
Figure 3-82. LCD Bezel
2. Secure the bezel with the two screws.
Figure 3-83. LCD Bezel Screws
Table 3-83. Screws
Step Screw Quantity Screw Type
LCD Bezel Reassembly M2.5 × L5 2
To Next Page
Loading...
