Machine Maintenance 3-65
Replacing the LCD Bezel 0
1. Place the bezel on the LCD module and press the bezel on all sides until it snaps into
place.
Make sure that the LCD, webcam, microphone, and antenna cables are properly routed
on the hinge sides and there is no gap between the bezel and the assembly lid.
Figure 3-100. LCD Bezel
2. Secure the bezel with the two (2) screws.
Figure 3-101. LCD Bezel Screws
Table 3-24. Screws
Step Screw Quantity Screw Type
LCD Bezel Assembly M2.5 x L5 2
To Next Page
Loading...
