Acer Aspire 4743Z - Changing a Password

2-10 System Utilities
Changing a Password 0
1. Use the  and keys to highlight Set Supervisor Password and press Enter. The
Set Supervisor Password dialog box appears.
Figure 2-6. Set Supervisor Password
2. Type the current password in Enter Current Password field and press Enter.
3. Type the new password in Enter New Password field. Retype the password in
Confirm New Password field.
Figure 2-7. Setup Notice
4. Press Enter. Computer sets Supervisor Password parameter to Set.
NOTE:
NOTE:
Users can enable the Password on boot parameter.
5. Press F10 to save changes and exit BIOS Setup Utility.
If the verification is OK, the screen shows as follows.
Figure 2-8. Setup Warning: Invalid Password
The password setting is complete after the user presses Enter.
Set Supervisor Password
Enter Current Password [ ]
Enter New Password [ ]
Confirm New Password [ ]
Setup Notice
Changes have been saved.
[Continue]
Setup Warning
Invalid Password
[Continue]