Precautions
Please follow all warnings, precautions and maintenance as
recommended in this user’s guide.
▀■ Warning- Do not look into the projector’s lens when the lamp is on. The bright
light may hurt and damage your eyes.
▀■ Warning- To avoid the risk of re or electric shock, do not expose this projector
to rain or moisture.
▀■ Warning- Please do not open or disassemble the projector as this may cause
electric shock.
▀■ Warning- When replacing the lamp, please allow the unit to cool down. Follow
instructions as described on pages 52.
▀■ Warning- This projector will detect the life of the lamp itself. Please be sure to
change the lamp when it shows warning messages.
▀■ Warning- When the lamp is approaching the end of its lifetime, the message
“Lamp Warning: Lamp life exceeded.” will show on the screen.
Please contact your local reseller or service center to change the
lamp as soon as possible.
▀■ Warning- Reset the “Clear Lamp Hours” function from the on-screen display
“Options | Lamp Settings” menu after replacing the lamp module
(refer to page 34).
▀■ Warning- When switching the projector off, please ensure the cooling cycle
has been completed before disconnecting power. Allow 90 seconds
for the projector to cool down.
▀■ Warning- Do not block the light path between the light source and the lens with
any objects. Doing so could cause the object to catch on re.
Usage Notice
To Next Page
Loading...
