Image has vertical ickering bar
Use “Clock” to make an adjustment. Refer to the “Screen” section for more
`
information.
Check and recongure the display mode of your graphic card to make it
`
compatible with the product.
Image is out of focus
Adjust the “Focus Ring” on the projector lens.
`
Make sure the projection screen is within the required distance. Refer to
`
Page 16.
The image is stretched when displaying 16:9 DVD title
When you play anamorphic DVD or 16:9 DVD, the projector will show the best
image in 16: 9 format on projector side.
If you play 4:3 format DVD title, please change the format as 4:3 in projector
`
OSD.
If the image is still stretched, you will also need to setup the display format
`
as 16:9 (wide) aspect ratio type on your DVD player.
Image is too small or too large
Move the projector closer to or further from the screen.
`
Press “Menu” on the remote control or on the control panel. Go to “Screen” -->
`
“Aspect Ratio”and try the different settings.
Image has slanted sides:
If possible, reposition the projector so that it is centered on the screen and
`
below the bottom of the screen.
Use “Screen” --> “V Keystone” from the OSD to make an adjustment.
`
Image is reversed
Select “Screen” --> “Ceiling Mount” from the OSD and adjust the projection
`
direction.
To Next Page
Loading...
