10
Powering on/off the projector
Powering on the projector:
Note that the connections to external equipment and power outlet should be done
before performing the operations written below.
Press Power on the projector or ON on the remote control.
• The power indicator illuminates green.
Warning
• Never look into the lens when the light is on. This can damage your eyes.
• This focal point concentrates high temperature. Do not place any object near it to avoid
possible fire hazard.
Powering off the projector:
Press Power on the projector or STANDBY on the remote control, then press
that button again while the confirmation message is displayed, to put the
projector into Standby mode.
• The projector cannot be turned on while cooling.
To Next Page
Loading...
