4 Chapter 1
• 2 reserved 2pin GPIO connector
• 1 Serial port header (COM2) (near rear IO is preferable)
• 1 TPM DB header (2x10) (*check Acer's TPM DB spec) (Refer to Appendix)
• 1 2pin Intrusion Alarm connector
• 1 LPT 2*13pin header (near rear IO is preferable)
• 1 2*4 pin internal speaker header
• Color management for on board connecter (please refer to Acer spec)
• Header Naming should follow MB Header Naming (Refer to Appendix)
• Braidwood connector (reserved)
• 1 3pin ME enable/disable connector (with 1 jumper)
System BIOS
• Size: 64Mb
• AMI Kernel with Acer skin/copyright
Power supply
• 300W/ in stable mode (Acer/GTW Assign System Power Unit)
• Design for Intel Piketon chipset compatible system
• Voltage design should be covered +5V, +3.3V, +12V, +5VSB, -12V (attention to 12V output capability)
• Demand for both PFC/Non-PFC solutions (two different quotations are needed)
• Active PFC with Energy Star 5.0
• EuP lot6 requirements
To Next Page
Loading...
