61 Chapter 5
System Board Header Setting
Refer to the following for information on connecting the motherboard’s header setting.
SATA1~6: Serial ATA connectors
These connectors are used to support the new Serial ATA devices for the highest data transfer rates (3.0 Gb/
s), simpler disk drive cabling and easier PC assembly. It eliminates limitations of the current Parallel ATA
interface. But maintains register compatibility and software compatibility with Parallel ATA.
Pin Signal Name Pin Signal Name
1 Ground 2 TX+
3 TX- 4 Ground
5 RX- 6 RX+
7 Ground - -
To Next Page
Loading...
