What to do if Acer X112 Projector is not responding?
If your Acer Projector stops responding to all controls, turn it off, unplug the power cord, and wait at least 30 seconds before reconnecting the power.
Why does my Acer X112 Projector lamp burn out?
When the lamp in your Acer Projector reaches the end of its useful life, it will burn out and may make a loud popping sound. If this occurs, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp" section.
Instructions for safely turning off the projector before cleaning.
Guidelines for safely connecting and disconnecting the power supply.
Ensuring power outlets are accessible for easy disconnection.
Details the outstanding features of the DLP projector.
Visual identification of projector parts from front/upper and rear sides.
Step-by-step guide for connecting the projector to sources.
Procedure for powering on the projector and source devices.
Instructions for adjusting the projector's height using elevator feet.
Onscreen display menu for projector installation and maintenance.
Instructions on how to navigate and use the OSD menus for settings.
Selection of factory presets for various image types.
Choosing a proper color to match the wall for accurate image tone.
Adjusts the image brightness, either darkening or lightening.
Settings for projector orientation: Front-Desktop, Rear-Desktop, Rear-Ceiling, Front-Ceiling.
Option to display or turn off closed captioning for video signals.
Dims the projector lamp for lower power consumption and extended life.
Controls the audio output level for the projector.
Adjusts the 3D format for correct display of 3D content.
Guide to resolving common image problems and their solutions.
Lists supported resolutions and frequencies for VGA analog PC signals.
To Next Page
General
