acrison 105-BB - Operational Adjustments

3.2.2 Variable Speed AC Drive
The discharge rate of any particular size metering auger may be adjusted over an infinitely
variable 10:1 (typical) drive turndown ratio by adjusting the output speed of the variable speed
drive. For complete information, please refer to the applicable variable speed AC controller
instruction manual.
3.3 Operational Adjustments
3.3.1
The speed (ratio) between the smaller metering auger and the Intromitter (or conditioning auger)
is preselected based on the characteristics of the specific material to be metered, factory preset
for optimum performance. If any feed-related problems are encountered, Acrison should be
consulted for assistance.
3.3.2
For feed rates beyond the furnished metering auger capacity, larger or smaller metering
auger/discharge cylinder sets may be available (which are only interchangeable on the individual
models of the 105 Feeder Series). The output capacities of the various size metering augers may
be obtained from the following Capacity Chart.
Size
30:1
Speed Range
50:1
Speed Range
Minimum Output Capacities
MODEL 105 SERIES CAPACITY CHART
(Capacities shown in cubic feet per hour)
Maximum
Output
105-BC 0.00760.0127
105-C 0.0180.03
105-D 0.0480.08
105-G* 0.580.97
105-F 0.280.47
105-E 0.120.2
105-A 0.00120.002
0.38
0.9
2.4
29
14
6
0.06
105-BB 0.01080.018 0.54
105-CC 0.0280.047 1.4
105-DD 0.0840.14 4.2
105-EE 0.1740.29 8.7
105-FF 0.380.63 19
105-GG* 0.841.4
105-N** 4.06.7
105-KK** 2.43.9
105-HH* 1.42.4
42
202
118
72
105-H* 1.021.7 51
105-K** 1.93.2 96
105-M** 3.25.3 160
105-B 0.0030.005 0.15
*Available on the Models 105X and 105Z only.
**Available on the Model 105Z only.
NOTE:
The preceding Capacity Chart indicates the typical output range
for each size metering auger available with Model 105 Series of
Feeders. However, since the physical properties of the actual
product being metered may have an effect upon the exact
output, the stated capacities could vary.
10