1.0 IMPORTANT SAFETY INSTRUCTIONS
Operator Safety
THIS EQUIPMENT CONTAINS ROTATING COMPONENTS. TO AVOID POSSIBLE BODILY INJURY,
POWER TO THIS EQUIPMENT MUST ALWAYS BE DISCONNECTED BEFORE THE EQUIPMENT IS
OPENED OR PRIOR TO PERFORMING ANY MAINTENANCE WHATSOEVER. DO NOT CLEAN
WHILE OPERATING. NEVER PERMIT AN OPERATOR OR ANY PERSONNEL TO PLACE HANDS,
FEET, APPAREL OR ANY OBJECT INSIDE OR NEAR THE INLET, OUTLET OR ANY FUNCTIONAL
AREA OF THIS MACHINE WHILE POWER IS ON.
This equipment can be installed in a variety of configurations predicated on the overall process design
and/or the physical equipment arrangement. It is the buyer’s or user’s sole responsibility to (1), define the
need for and to subsequently ensure that any safety device(s) or associated safety device(s), other than
that normally furnished by Acrison as standard, is provided in accordance with the specific installation
and operational parameters of the equipment, and (2), define the need for and assure compliance with all
applicable safety laws, rules and regulations.
If safety devices are not specifically included with the original equipment (based on the specifics of a
given installation), Acrison can, at the user’s expressed request only, provide whatever safety device(s)
the buyer or user deems applicable. If Acrison is asked to make such recommendations prior to operation
of the equipment, said recommendations are only advisory and do not impose any obligation or liability
upon Acrison unless Acrison is expressly requested to provide the safety device(s), and does so.
It is the buyer’s or user’s sole responsibility to establish safety procedures and operational instructions to
safeguard the operator(s) during maintenance, cleaning or any use of the equipment whatsoever and to
subsequently ensure that the equipment is operated in conformance with all applicable safety procedures,
laws, regulations and instructions. It is also the buyer’s or user’s sole responsibility to enforce all safety
regulations and operational instructions and to maintain the equipment in a safe condition (guards in
place, warning, caution and/or important labels affixed, electrical boxes secure, interlocks operational,
etc.). In particular, all warning and caution labels must be maintained in a readable condition and, if
necessary, replaced with new labels. These labels are available free of charge on request from Acrison
Incorporated.
Because the nature of the equipment does not always make it possible to prevent operator access to
rotating components, under no circumstances should maintenance or cleaning be performed on the
equipment without first disconnecting all power.
The above WARNING and CAUTION symbols, where displayed within this Manual, are intended to
draw the attention of the user to a potential for risk of personal injury and/or damage to the
equipment if the correct operating procedures are not followed.
IMPORTANT
The equipment is supplied for the specific duty for which it was originally sold and as stipulated on
Acrison’s Equipment Specification and Parts List Documents. It is not recommended to use this
equipment for any other purpose without the expressed written consent of Acrison Incorporated.
WARNING
CAUTION
²
²
3
To Next Page
Loading...
