ASCON Service Guide Book
15
4. Fan speed selection
•
Press the button continuously will toggle the fan speed in the following order: Low ( ) –––:
Med ( ) –––: High ( ) –––: Auto
•
Stop pressing when the desired fan speed appears on the display screen.
5. ON Timer Setting
•
Press the SET button will activate the on timer function.
•
Set the desired on time by pressing the SET button continuously. If the timer is set to 7.30am,
the air conditioner will turn on at 7.30am sharp.
•
Press the CLR button to cancel the on timer setting.
6. OFF Timer Setting
•
Press the SET button will activate the off timer function.
•
Set the desired off time by pressing the SET button continuously.
•
Press the CLR button to cancel the off timer setting.
7. Automatic Air Swing
•
Press the SWING ( ) button to activate the automatic air swing function.
•
To distribute the air to a specific direction, press the SWING button and wait until the louver
move to the desired direction and press the button once again.
8. Sleep Mode Setting
•
Press the SLEEP button will activate the sleep mode function. This function is available under
COOL, HEAT and AUTO mode.
•
When the unit is operating under cooling mode, the set temperature is increased by 0.5°C
after 30 minutes, 1°C after an hour, and 2°C after 2 hours.
•
When the unit is operating under heating mode, the set temperature is decreased by 1°C after
30 minutes, 2°C after an hour and 3°C after 2 hours.
9. Clock Time Setting
•
Press + button to increase the clock time.
•
Press – button to decrease the clock time.
10. Turbo Mode
•
Press the TURBO ( ) button to achieve the required set temperature in a short time.
11. Ionizer
•
Press the Ionizer ( ) button to activate the negative Ion function, which will refresh the
indoor air effectively.
12. Personalize Setting
•
Press button and hold for 3s to initiate personalized setting
•
Set the individual setting e.g. MODE, SET TEMP or FAN SPEED and leave for 4s to save the
setting into the program.
•
2 groups of settings are allowed to store in the handset. Press once to activate the P1 setting,
press again to cycle between P1 and P2.
•
Press any key to deactivate the personalize setting.
To Next Page
Loading...
Need help?
General
