ASCON Service Guide Book
16
5.3 G18
Outlook
Operation Guide
1. Transmission Source
•
The source where the signal will be transmitted.
2. Signal Transmission Indication
•
Blink to confirm that the last setting has been transmitted to the unit.
3. Temperature Setting
•
To set the desired room temperature, press the
▲
or
▼
button to increase or decrease
the set temperature.
•
Temperature setting range is from 16°C to 30°C (optional setting 20°C to 30°C).
4. Personalize Setting
•
Press and hold for 3s, then will blink. Press again to cycle between and .
•
Set the desire setting, then leave the handset for 4s without pressing any key and it will save
the setting into the program.
•
Press once to activate the P1 setting, press again to cycle between P1 and P2.
•
Press any key to deactivate the personalize setting.
To Next Page
Loading...
Need help?
General
