Acson AWM User Manual

ASCON Service Guide Book
26
5.7 Sequential Controller
Outlook
Operating Guide
1. “ON/OFF” Switch
• Press once to start the air conditioning unit.
• Press again to stop the unit.
• The operation lamp next to the key lights up and goes off respectively when the unit is
running or not running.
• Caution: In the case when the ON/OFF key is pressed immediately after the operation is
stopped, the unit will not restart until 3 minutes later to protect the compressor.
2. Selecting Operating Mode
• Press the MODE key to select the type of operating mode. Consecutive press of the key
switches the operation over “ COOL ”, “ HEAT ”, “ AUTO ” and “ FAN ”
3. SAVE Mode
• Press the SAVE key to select the energy saving function. This option is only available for
“ COOL ”, “ HEAT ” and “ AUTO ” modes.
4. Auxiliary Electric Heater
• If the “ HEAT ” mode provides insufficient heating to a room even at the highest temperature
setting (30°C), press the HEATER key to activate the auxiliary electric heater. For models
with two heaters, consecutive press of the key allows the selection of one or both heaters
active.
A : Time display
B : Error indication
C : Compressor running display (up
to 4 compressors)
D : Key lock display
E : Heat display (up to 2 heaters)
F : Energy saving mode display
G : Compressor deforst cycle display
(up to 4 compressors)
H : Operation mode display
I : Temperature set display

Acson AWM Specifications

General

Brand	Acson
Model	AWM
Category	Air Conditioner
Language	English