A
CTpro 3000 Operating Instructions Firmware Version 1.24
6
1) Select Group Group 3 0 for next group
Timed Access
✔ to display access rights
2) Displaying access rights A B C D E F G H + - 0 for next combination
At all times ✔ to change combination
Selected Doors
6) Setting No Access A B C D E F G H + - ✔ to set no access
No Access?
5) Setting Full Access A B C D E F G H + - ✔ to set full access
Full Access?
3) Changing timezone Timezone 0 for next timezone
At all times
✔ to select
4) Changing door combination Door 7 0 for next door
[23---7—AB] ✔ to select/deselect
✘ when done
In addition, Full Access or No Access may quickly be set for the group by highlighting and
selecting the + or - symbols respectively:
▼
▼
ASSIGN OPTIONS
The Assign Options menu can be used to apply additional options to a group. The assigned
options are displayed in brackets in the form [23TB] with non-assigned options displayed as a
dash. Pressing the ✔ key allows the options to be altered. When changing options, the 0 key
advances to each option, and the ✔ key selects or deselects the displayed option.
Option Description
2 Activate O/P 2 The general-purpose output OP2 is activated for its programmed
duration when users in this group are granted access.
3 Activate O/P 3 The general-purpose output OP3 is activated for its programmed
duration when users in this group are granted access.
T Toggle Relay When the user is granted access, the relay is toggled so the door
will remain permanently open until the next time the card or
token is read. The door must be set for Toggle Relay operation.
B Track Bypass If tracking bypass is enabled, then users in this group are always
allowed access through antipassback doors.
Note: The options assigned to an individual user operate in addition to those assigned to the group.
ASSIGN PINS
The Assign PINs function allows a different PIN to be assigned to each group of users. Initially, the
PIN will be unset. Pressing the
✔
key will prompt for the PIN for the displayed group to be entered