ACTpro 3000 Operating Instructions Firmware Version 1.24
3
User Setup
The User Setup menu allows the operator to enable and disable individual users, and to change
the configuration information for each user. In each of the user setup functions, the user is selected
by either using the 0 key to advance to the required user, or alternatively by using the numeric keys
1-9 to directly enter the number of the desired user. The top line of the display will show the name
for each user if one has been entered, otherwise the number only will be displayed.
ENABLE
The Enable function allows a user or range of users to be enabled. Pressing the ✔ key enables the
displayed user. This means that the card or token belonging to this user will be recognized and
may be allowed entry to the protected area. Note that the Group Disable function or programmed
access rights may override an enabled user.
DISABLE
The Disable function allows a user or range of users to be disabled. Pressing the ✔ key disables
the displayed user. This means that the card or token belonging to this user will no longer be
recognized and will not allow entry to the protected area.
ASSIGN NAMES
The Assign Names function allows a 16 character textual name to be assigned to users between 1
and 5,000. This name will be shown with any displayed or printed log events involving this user.
Pressing the ✔ key selects text entry mode.
ASSIGN GROUPS
The Assign Groups function allows a user or range of users to be assigned to a group. Any of the
30,000 users can be assigned to one of 1024 groups.
The Display will show the user number on the top line and the group that that user is assigned to
on the bottom line. The displayed user number may be advanced by the 0 key. Also any user may
be displayed by entering the user number, and then pressing the ✔ key followed by the ✘ key.
Pressing the ✔ key prompts for a group number to be entered, entering the group number and
pressing the ✔ key again assigns the currently displayed user to the group entered.
A range of users may be assigned to the displayed group number, entering the first user number
in the range of users followed by the ✔ key, and then entering the last user number followed by
the ✔ key will assign all the users in the range to the group displayed. This method can also be
used to assign a single user to a group by entering the same user number for the first and last user
in the range.
ASSIGN OPTIONS
The Assign Options function allows additional options to be assigned to each of the 30,000 users.
The available options are displayed in brackets in the form [23TRA] with non-assigned options
displayed as a dash. Pressing the ✔ key allows the options to be altered. When changing options,
the 0 key advances to each option and the ✔ key selects or deselects the displayed option.
To Next Page
Loading...
