ACTi E933 - Page 13

www.acti.com
Hardware Manual
13
Item
Description
1
Memory
Card Slot
Insert a memory card (not included) into the slot for local recording
purposes. See How to Install / Remove the Memory Card on page 25
for more information.
NOTE: Supports only microSDHC and microSDXC cards.
2
Power LED
Lights up when the camera is powered up and goes off after the boot up
process is complete
3
Reset
Button
Restores the factory default settings of the camera. To reset the camera,
while the power is on, press and hold the Reset Button for at least 5
seconds or until the Power LED lights up.
4
Ethernet
Port (M12)
Connects to a network using an Ethernet cable with M12 connector. The
camera uses the female M12 connector with D-coding and PoE type A.
5
Audio Input
Connects to audio input devices, such as a microphone with built-in
amplifier, etc. See How to Connect Audio In Device on page 29 for more
information.
NOTE: The microphone must have a built-in amplifier. Connecting an
ordinary microphone will dwarf sounds and will result in inaudible
recording.