Display Mode
e Receiver supports three display modes when connected to a compatible wireless display
application (Intel WiDi or Windows 10/8.1 Project, for example). To launch display options,
press the
(Windows logo) and P keys simultaneously to generate the display options screen
(the upper gure is for Windows 10; the lower, Windows 8.1):
Duplicate
Clicking Duplicate from the display mode menu enables Duplicate mode. is mode is used to
display the same content on both the device's screen and the HDTV simultaneously.
Note: ere may be minor delay between the content displayed on the HDTV screen
compared to the device’s screen. is is due to the current state of wireless display
technology.
Extend
Clicking Extend from the display mode menu enables Extend mode. is mode creates a single,
extended “screen” between the source device and the HDTV. When in Extend mode, dragging
windows to the right side of the device's screen displays those windows on the HDTV, while
dragging windows to the le of the HDTV screen displays them back on the device's screen. is
allows users to display selected content on the HDTV, while all other windows remain on the
device's screen. When this mode is rst selected, the HDTV displays only the Windows desktop.
To Next Page
Loading...
