NVIDIA Shield does not see my ScreenBeam Mini 2 Receiver, or it sees the
Receiver as “unavailable” or “busy” even after a rescan.
Exit out of the NVIDIA’s Miracast settings window and go back.
My Windows 8.1 displays to the TV but the four edges are cut o (overscan).
is is expected with some system’s supported display resolution. You can adjust Windows
screen resolution settings to t the computer’s screen on your TV display.
When I connect to an access point or wireless router with an active WiDi
session, the WiDi connection drops.
is is a known issue with Intel WiDi, and happens with either 3.5.41.0 or 4.0.1.8 on both
Windows 7 and 8. Re-connect the WiDi session or connect to the AP rst before starting a
WiDi session.
I encounter connection failure with ScreenBeam Mini 2 and my device can’t
connect to it any more.
•
Reboot the Receiver and try connecting again. Or, reboot your device and try
reconnecting.
•
Reboot both the Receiver and your device and try connecting again.
•
If you are using a Windows 8.1 operating system, go to Change PC settings > PC and
Devices > Devices > Projectors, then remove the prole of ScreenBeam Mini 2 from
your device, and try connection again.
I can’t connect to the Receiver with ScreenBeam Conguration Utility on my
device. The Utility can’t nd the Receiver.
In Windows 8.1, you must connect your device to the Receiver at least once. In doing so, the
prole of the Receiver is saved to your device. en the Utility on your device can connect to
the Receiver.
In Windows 7/8, you must connect your device to the Receiver with Intel WiDi rst, and
then the Utility on your device can connect to the Receiver.
In Windows 8.1, I can’t adjust the screen size with the ScreenBeam
Conguration Utility. I can’t nd the screen size adjustment option.
e screen size adjustment option is not available if your device doesn’t connect to the
Receiver. You must connect your device to the Receiver rst, and then launch the Utility and
congure the receiver.
To Next Page
Loading...
