12
Operating Instructions
6. Operating Instructions (cont.)
6.2 Shutting Down and Cleaning Up
1
Turn o water supply and disconnect the
garden hose from the water inlet on the
pressure washer.
2
Pull the trigger to release any remaining
water pressure.
3
Set the ON/OFF switch to the OFF position.
4
Unplug the power cord from the outlet.
5
Engage the safety lock on the spray gun.
1
Engage the safety lock on the the
spray gun.
2
Set the ON/OFF switch to the OFF position.
3
Unplug the power cord from the outlet.
WARNING
Turn o the water supply and pull the trigger to
depressurize the device. Failure to do so might
result in personal injury due to discharge of
high-pressure water.
CAUTION
Failure to clean this product properly will cause
the detergent injection system to become
clogged and inoperable.
WARNING
Never use:
• Bleach, chlorine products or other
corrosive chemicals
• Liquids containing solvents
(i.e., paint thinners, gasoline, oils, etc.)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will
damage the surface being cleaned.
6.3 Taking Breaks
If taking a five minute or longer break while using
the pressure washer:
6.4 Warnings
To Next Page
Loading...
