13
Winterizing and Long-Term Storage
WARNING
Flush the pressure washer unit out with clear
water before reusing. Anti-freeze can damage the
paintwork and product, so you must ensure there
is no anti-freeze le in product system before
using it again.
CAUTION
Drain any remaining water from the gun assembly.
Aim the gun downwards and pull the trigger.
WARNING
Store the pressure washer unit in a location where
temperature does not fall below 32°F (0°C) at all
times. The pump in the machine is susceptible to
damage if exposed to cold temperatures. FREEZE
DAMAGE IS NOT COVERED BY THE WARRANTY.
7.2 Quick Winterizing Procedure
If you are unable to perform the Optimum
Winterizing Procedure, you can still protect your
pressure washer from winter damage by doing
the following:
• Disconnect all water connections.
• Turn on the device for a few seconds, until the
remaining water flows out of the pump. Turn
the device off immediately after that.
• Do not allow the high-pressure hose to
become kinked.
• Store the device and its accessories in a room
that does not reach freezing temperatures.
Do not store them near furnaces or other
sources of heat, as that might dry out the
pump seals.
• Recommended: Pressure Washer Antifreeze.
7.1 Optimum Winterizing Procedure
Winterizing your pressure washer will help
protect and prolong its life. We strongly
recommend you follow the below steps using a
Pressure Washer Antifreeze before storing for the
winter. This will keep the internal parts lubricated,
protected from rust, and prevents the pump
from freezing.
1. Connect the Pump Saver to the inlet adaptor.
2. Depress button on top of the pump saver
container.
3. Continue until fluid exits the pressure hose.
4. Remove the hose from pump inlet.
7. Winterizing and Long-Term Storage
To Next Page
Loading...
