7
Assembly Instructions
5. Assembly Instructions
5.1 Surface Preparation
Before beginning any cleaning task, it is
important to inspect the area for objects that
could create a hazard. Remove any objects from
the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors
and windows are closed tightly.
5.2 Water Supply (Cold Water Only)
Only draw water through the unit. The device
must be used with cold water supply only. The
water hose must be at least 1/2” (13 mm) in
diameter. The water flow rate must not fall below
2 GPM (9.1 LPM). The flow rate can be determined
by running water for one minute into an empty
container. The water supply temperature must
not exceed 40 °C (104 °F).
5.3 Safety Advice
5.4 Assembly
CAUTION
• Never use the pressure washer to draw in
water contaminated with solvents (e.g. paint
thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit.
To avoid this risk, we recommend checking
the water filter (located inside the water
inlet. To clean it out, refer to the Cleaning and
Maintenance section).
• Always prevent debris from being drawn into
the unit by using a clean water source and an
additional accessory water filter, if required.
• To prolong the life of the unit, let it rest for 5
minutes aer every 30 minutes of use.
• Check to make sure you have all the parts.
Assemble the hose holders.
Assemble the gun holder.
Assemble the cord bracket and bottle holder.
1
2
3
To Next Page
Loading...
