ACU-RITE 01022 - Alarm Management Procedures; Setting a New Weather Alarm; Disabling Weather Alarms

21
Setup an Alarm
Press and release the “select” button until the reading for which you wish to set
an alarm for is shown on the Weather Ticker screen.
1. Press and release the “alarms” button to enter ALARM SET MODE.
2. Press and release the “
SET
enter
” button.
3. Press and release the “ ” or “ ” buttons until “ALARM ON” is ashing
on the Weather Ticker screen.
4. Press and release the “
SET
enter
” button. The current LOW alarm value will be
shown on the display.
5. Press and release the “ ” or “ ” buttons to adjust the alarm’s LOW value.
6. Press and release the “
SET
enter
” button. The current HIGH alarm value will be
shown on the display.
7. Press and release the “ ” or “ ” buttons to adjust the alarm’s HIGH value.
8. Press and release the “
SET
enter
” button.
9. Repeat steps 1-8, as needed.
Disable an Alarm
Press and release the “select” button until the reading for which you wish to set
an alarm is shown on the Weather Ticker screen.
1. Press and release the “ alarms ” button to enter ALARM SET MODE.
2. Press and release the “
SET
enter
” button.
3. Press and release the “ ” or “ ” buttons until “ALARM OFF” is ashing
on the Weather Ticker screen.
4. Press and release the “
SET
enter
” button.
5. Repeat steps 1-4, as needed.
NOTE: To disable ALL alarms at once, press and HOLD the “ alarms ” button for
15 seconds.