20
Start-up
The navigation system starts automatically when you set the power mode to
ACCESSORY or ON. At start-up, the following Confirmation screen is displayed.
1. Press to continue.
u If you do not press , the map
screen is displayed after a
certain period of time.
u The system will automatically
start up the feature that was
used the last time.
2. Press the NAV button if a different
mode is selected.
u Your current position is
displayed on the map screen.
1 Start-up
If the navigation system loses power at any time, you
may need to press and hold the (Power) button
for more than two seconds, or you may be prompted
for the five-digit security code.
2 System Initialization P. 150
At start-up, the driver’s keyless access remote is
automatically detected and the address book
settings, setup preferences, wallpapers, and audio
settings for that driver (e.g., Driver 1) are loaded.
“OK” on the Confirmation screen cannot be selected
by using a voice command.
19 ACURA ILX NAVI-31TX68600.book 20 ページ ２０１８年８月８日 水曜日 午後２時２１分
To Next Page
Loading...
Need help?
General
