4
SETUP
Install or Replace Batteries
AcuRite recommends high quality alkaline batteries for the best product performance.
Heavy duty or rechargeable batteries are not recommended.
The outdoor sensor requires lithium batteries in low temperature conditions. Cold
temperatures can cause alkaline batteries to function improperly. Use lithium batteries in
the outdoor sensor for temperatures below -4˚F / -20˚C.
Display
1. Slide off the battery compartment cover.
2. Insert (3) AAA batteries into the battery
compartment, as shown. Follow the polarity
(+/-) diagram in the battery compartment.
3. Replace the battery cover.
Outdoor Sensor
1. Slide off the battery compartment cover.
2. Insert (2) AA batteries into the battery
compartment, as shown. Follow the polarity
(+/-) diagram in the battery compartment.
3. Replace the battery cover.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN
ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an
extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only
batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak.
DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circui
the supply terminals.
To Next Page
Loading...
