Need help?Do you have a question about the Aczet CY 3102 and is the answer not in the manual?
Essential safety guidelines for operating the balance to prevent damage and injury.
Important warnings regarding balance operation and environment.
Guidance on selecting the best placement for accurate weighing.
Explains the function of each key on the balance interface.
Step-by-step guide for performing a simple weighing operation.
Procedure for zeroing the balance with an empty container before weighing.
Step-by-step instructions for performing internal calibration.
Steps for performing a calibration test with actual calibration.
Functionality for counting pieces added to or removed from the weighing container.
Function to weigh to a preset value or determine percentage deviations.
Feature allowing weighing in user-defined units.
Functionality for weighing animals in motion using auto or manual modes.
Feature to verify samples against target values and tolerances.
Explains how to select External Calibration (CAL Et) or Internal Calibration (CAL Int).
Procedure to reset balance settings and functions to factory defaults.
Functionality for counting pieces based on a reference weight.
Steps to perform percent weighing against a preset value.
Application to determine moisture loss percentage from a sample.
Application to determine the dry content percentage of a sample.
Steps to perform weighing in a user-defined unit.
Setting the conversion factor for custom units.
Performing animal weighing with manual countdown settings.
Performing animal weighing with automatic countdown.
Procedure for summing individual weighing values manually.
Procedure for automatically summing individual weighing values.
Steps for checking samples against target and tolerance values.
Setting the target, high, and low values for check weighing.
Procedure for summing individual weighing pieces manually.
Procedure for automatically summing individual weighing pieces.
Setting the temperature of the liquid for density determination.
Selecting the type of liquid (water, ethanol, other) for density measurement.
Selecting the mode (compensated, uncompensated, gold) for density determination.
Setting the number of calibration cycles for pipette calibration.
Setting the temperature for pipette calibration.
Setting the pressure for pipette calibration.
Setting initial, half, and full volumes for pipette calibration.
Steps to obtain statistical data from the scale.
Procedure to set the time on the balance.
Procedure to set the date on the balance.
Configuring time intervals for automatic calibration.
Configuring temperature thresholds for automatic calibration.
Lists common error codes, their causes, and solutions.
Details specific error codes, their causes, and resolutions.
Addresses issues like unstable readouts and incorrect weights.
To Next Page
General