To Next PageTo Next Page
Need help?Do you have a question about the Aczet CZ 302 and is the answer not in the manual?
General| Capacity | 300 g |
|---|---|
| Readability | 0.01 g |
| Linearity | ± 0.02 g |
| Display | LCD |
| Units | g, ct, oz, lb, dwt |
| Auto Power Off | Yes |
| Overload Protection | Yes |
| Repeatability (Std. Dev.) | 0.01 g |
| Stabilization Time | 3 seconds |
| Calibration | External |
| Power Supply | AC adapter |
Importance of carefully reading the operation manual before setup and commissioning.
Explanation of why and when calibration is necessary due to gravity variations and environmental changes.
Steps involved in the calibration process, including using the recommended adjustment weight.
Detailed step-by-step guide for calibrating non-NTEP models using display and operation sequences.
Detailed step-by-step guide for calibrating NTEP models using display and operation sequences.
Explanation of linearization to improve accuracy by correcting linearity deviations.
Step-by-step guide for performing linearization on non-NTEP models with low resolution.
Procedure for linearization covering both non-NTEP low resolution and NTEP models.
Step-by-step instructions for performing a basic weighing operation on non-NTEP and NTEP models.
Detailed procedure for simple weighing specifically for non-NTEP model balances.
Detailed procedure for simple weighing specifically for NTEP model balances.
Instructions on how to tare the balance to exclude the weight of a container.
Procedure for taring the balance with non-NTEP models.
Procedure for taring the balance with NTEP models.
Explanation of the parts counting function and its importance for counting exactness.
Step-by-step guide for using the parts counting function on non-NTEP models.
Step-by-step guide for using the parts counting function on NTEP models.
Identifies common faults like non-glowing display or permanent changes and their possible causes.
