Adam Sub7 Owner's Manual

6
a)
b)
c)
d)
e)
4. Quick Start / Connection
Before connecting the subwoofers to your audio components and the
power source make sure that both the subwoofer and your audio system
are switched off and set the level controls fully counterclockwise.
Input
Connecttheleftandrightline-levelsignalfrom
yoursignalsource(preamplier,mixer,etc.)to
the LEFT and RIGHT INPUT jacks. Use either
XLR(balanced)orRCA(unbalanced)cables.In
mostprofessionalapplicationsXLRwillbethe
bestchoice,whileRCAismorecommoninHiFi
applications.
Satellite Out
Connect the LEFT and RIGHT SATELLITE OUT
jacks to the inputs of the left and right main
powered speakers or the inputs of the amps
poweringthemainspeakers.
Checkifthespeciedvoltagematchesthevoltageofthepowersupplyyou
use.Ifthisisnotthecasedonotconnectthesubwooferstoapowersource!
Pleasecontactyourlocaldealerornationaldistributor.
Ifthevoltagesmatch,usetheincludedpowercablestoconnectthesubwoofer
totheACsockets.
Switchonthemainon/offswitchesonthebackpanelofthesubwoofers.
Switchonyouraudiosystemandadjustthevolumeofboththeaudiosystem
andthesubwoofercarefully.
g. 2: Inputs
g. 3: Outputs

Adam Sub7 Specifications

General

Subwoofer type	Active subwoofer
Subwoofer frequency range	32 - 150 Hz
Subwoofer crossover frequencies	50 - 150 Hz
Product color	Black
XLR in	Yes