CLEARPASS Full-Body Security Screening System
OPERATION
MANUAL
Identification
ADN190.00.00.000 OM2
Revision
1
Date
02.2022
Page
14 of 52
2 SAFETY
2.1 GENERAL
The design of the System ensures its safe operation. The personnel working with the
System must be familiar with the current standards, rules and instructions on safety measures,
have special training on these issues, know the safety measures required when working with
X-ray equipment and undergo the retraining periodically.
2.2 RESPONSIBILITIES
Personnel working with the System should take appropriate safety precautions to protect
persons from X-rays that may affect them through negligence or ignorance.
THE SYSTEM MUST ONLY BE HANDLED BY PREVIOUSLY
TRAINED AND QUALIFIED PERSONNEL, AUTHORIZED TO
PERFORM THE OPERATION AND ITS MAINTENANCE.
FOLLOW THE INSTRUCTIONS GIVEN IN THIS MANUAL FOR A
LONG-TERM AND SAFE OPERATION OF THE SYSTEM.
READ THOROUGHLY THIS MANUAL PRIOR TO USING THE
SYSTEM AND KEEP IT AT THE OPERATOR’S AWS.
THE REQUIREMENTS OF THIS SECTION SHOULD BE THOR-
OUGHLY STUDIED PRIOR TO PUTTING THE SYSTEM INTO
OPERATION.
THE SYSTEM IS DANGEROUS TO BOTH THE INSPECTED
PERSON AND THE OPERATOR UNLESS PROTECTIVE
MEASURES ARE STRICTLY OBSERVED.
IT IS THE RESPONSIBILITY OF THE PERSONNEL TO EN-SURE
THE SAFETY OF THE INSPECTED INDIVIDUAL DUR-ING X-RAY
SCREENING. THIS IS ACHIEVED BY PRECISE FOLLOWING TO
THE SANITARY REGULATIONS OF WORK WHEN PERFORMING
THE X-RAY SCREENING, BY INDICA-TION OF THE VALID
REGULATORY DOCUMENTS ON RADIA-TION SAFETY AND
VISUAL INSPECTION.
THE SYSTEM DESCRIBED HEREIN IS SOLD WITH THE UN-
DERSTANDING THAT THE MANUFACTURER (ADANI
SYSTEMS), ITS AGENTS, AND REPRESENTATIVES ARE NOT
LIABLE FOR INJURY OR ANY DAMAGE WHICH MAY RESULT
FROM OVEREXPOSURE OF INSPECTED PEOPLE OR
PERSONNEL TO X-RADIATION DUE TO BUYERS FAULT.
To Next Page
Loading...