124
BP Battery tem-
perature is too
high or too
low
1. Check if battery is very hot. If necessary, place the
robot in the shade. Wait until the battery has cooled
down and restart.
A canopy protects the robot from weather and wind.
2. Check if the battery temperature is too low (do not
leave the robot outside if the temperature drops below
0 degrees).
Wait until the battery is in an environment above 5
degrees and restart.
3. If this does not solve the problem, the battery is prob-
ably damaged and needs to be replaced.
EE Unknown
error
1. The top cover may not be installed correctly. Press it
firmly down over the machine
2. Restart the robot. Turn off the robot and wait 10 sec-
onds.
3. Turn the robot on again, enter the password, press
START and then OK.
If the error code still appears, contact Schou.
- Increased
noise
Poor cutting
result
1. The blades are stuck with grass and cannot rotate
freely. Dismantle the blades, clean off the grass and
reattach.
2. Restart the robot. Turn off the robot and wait 10 sec-
onds.
3. Turn the robot on again, enter the password, press
START and then OK.
If the error code still appears, contact Schou.
- The robot
runs in circles
around itself
1. Check if one of the wheels can turn without resist-
ance. If this is the case, the spring cotter pin in that
wheel may be broken and needs to be replaced. Con-
tact Schou.
Display Message Solution
To Next Page
Loading...