Appendix D: Using the ACU for DOS ● 113
Sample Scripts
The MS-DOS command below invokes the ACU and creates arrays on
controller 1 based on the array keywords defined in the script file
A:\RAID.ACU
. It also configures Channel 0 and saves a log of the
operation in the log file
C:\RAID.LOG
:
A:\> ACU /P A:\RAID.
ACU
/L C:\RAID.LOG /C1
Sample Scripts for SCSI and SAS Controllers
Note: For a sample script for a SATA controller, see page 114.
This sample script file is a sample
RAID.ACU
script as referred to in the
ACU command above. This script creates these arrays—a 500 MB
single-disk volume, and a 2-GB two-disk drive RAID 1 with a hot spare:
# Script to create volume, mirror, and RAID 5 arrays
# Create a 500MB volume labeled ‘MySystem’
Array=MySystem
Type=Volume
Size=500MB
Drives=0:0:0
End
# Create a 2GB mirror labeled ‘MyMirror’
Array=MyMirror
Type=RAID1
Size=2GB
# Use drives 1 and 2
Drives=0:1:0,0:2:0
# Disable write cache
WriteCache=No
# Assign 1 spare drive
HotspareDrives=0:3:0
End
To Next Page
Loading...
