Chapter 8: Installing the Driver on an Existing Operating System ● 58
Installing on Windows
To install the driver on Windows:
1 Start or restart Windows.
The Found New Hardware Wizard opens and searches for the driver.
2 Insert the driver disk, select Floppy drive, then click Next.
3 Click Next, then click Next again.
4 Follow the on-screen instructions to complete the driver
installation.
5 Remove the driver disk and restart your computer.
6 Continue with Managing Your Storage Space on page 60.
Installing on Red Hat or SuSE Linux
To install the module on Red Hat or SuSE Linux:
1 Insert and mount the RAID Installation CD:
Red Hat: mount /dev/cdrom /mnt/cdrom
SuSE: mount /dev/cdrom /media/cdrom
2 Install the module RPM:
rpm -Uvh mount-point/xxx/yyy.rpm
where mount-point is the specific mount point on the Linux system,
xxx is the driver path, and yyy.rpm is the rpm file.
3 Run
fdisk
,
mkfs
, and create mount points for any new disk drives.
4 Continue with Managing Your Storage Space on page 60.
To Next Page
Loading...
