Appendix C: Using the Adaptec RAID Controller Utility ● 91
Introduction to the Adaptec RAID Controller
Utility
The Adaptec RAID Controller utility comprises these tools:
● The Array Configuration Utility (ACU)—For creating and
managing arrays, and initializing and rescanning disk drives (see
page 92).
Note: Also available—ACU for DOS. See page 101.
● A -Select Utility—SerialSelect, SATASelect, or SCSISelect, for
modifying your controller and disk drive settings (see page 95).
● Disk Utilities—For formatting or verifying disk drives (see page 99).
Running the Adaptec RAID Controller Utility
If your Adaptec controller is connected to a RAID enclosure, power on
your enclosure (or enclosures) before you power on your computer.
Start or restart your computer. When prompted, press Ctrl+A.
Note: The first time you power on your computer after you install a
new controller, the BIOS may display a configuration that doesn’t
match your system’s configuration. This is normal.
Navigating the Adaptec RAID Controller Utility
All the tools within the Adaptec RAID Controller utility are menu-
based and instructions for completing tasks appear on-screen. Menus
can be navigated using the arrows, Enter, Esc, and other keys on your
keyboard.
To Next Page
Loading...
