Chapter 7: Installing the Driver and an Operating System ● 53
Installing with Red Hat Linux
Note: You will need your Red Hat installation CD to complete this task.
To install the ICP RAID controller driver while installing Red Hat
Linux:
1 Insert the first Red Hat installation CD.
2 Restart your computer.
3 When the Red Hat Welcome screen appears, type linux dd at the
Boot: prompt.
4 When prompted, insert the driver disk, then select OK.
5 Follow the prompts to set up the environment you want.
6 If you are installing other third-party devices, install them now.
Otherwise, select Done.
7 Complete the Linux installation, following the instructions included
with your operating system.
8 Continue with Managing Your Storage Space on page 60.
Installing with SuSE Linux
To install the ICP RAID controller driver while installing SuSE Linux:
1 Insert the first SuSE installation CD.
2 Restart your computer.
3 When the SuSE installation selection screen appears, choose the type
of installation you want, then press the F6 key to indicate the use of a
driver disk. (If
F6 is not shown on the screen, you may have an older
version of SuSE; press the Alt key instead.)
4 When prompted, insert the driver disk, then press any key to
continue.
5 Follow the prompts to set up the environment you want.
6 If you are installing other third-party devices, install them now.
Otherwise, select Back.
To Next Page
Loading...
