Chapter 7: Installing the Driver and an Operating System ● 52
8 Continue with the instructions for your operating system:
● For Windows, see below.
● For Red Hat Linux, see page 53.
● For SuSE Linux, see page 53.
● For NetWare, see page 54.
Installing with Windows
Note: You will need your Windows installation CD to complete this
task.
To install the ICP RAID controller driver while installing Windows:
1 Insert your Windows CD, then restart the computer.
2 Follow the on-screen instructions to begin the Windows installation.
3 When prompted to install a third-party driver, press F6
.
Note: When F6 is active, a prompt appears at the bottom of the
screen for only 5 seconds. If you miss your chance to press F6, restart
your computer.
4 Insert the driver disk, then wait until you are prompted to install a
driver.
5 Press S to specify that the driver is on a floppy disk, then press Enter.
The computer reads the disk.
6 When the ICP driver is found, press Enter.
7 Follow the on-screen instructions to complete the installation.
8 Continue with Managing Your Storage Space on page 60.
To Next Page
Loading...
