How to fix a very loud or distorted output on my Adastra Amplifier?
If the Adastra Amplifier output is very loud or distorted, first, ensure the input signal level isn't too high. Then, reduce the MIC, LINE IN, MEDIA, and/or MASTER level. Also, verify that Hi-Z line level inputs are not connected via the MIC input.
What to do if my Bluetooth cannot connect to Adastra UM Amplifier?
To troubleshoot Bluetooth connectivity issues with your Adastra Amplifier, first, ensure the sending device is within the Bluetooth range (5-10m). If it's in range, check that the connected device is the correct ID.
Why is my Adastra Amplifier overheating or cutting out?
If the Adastra Amplifier is overheating or cutting out, check that 8Ω speakers are not connected to 100V terminals. Ensure the total 100V speaker wattage is lower than the amplifier rating and that 100V and 8Ω speakers are not both connected.
Why is there no audio from connected Bluetooth device on my Adastra Amplifier?
If there is no audio from a connected Bluetooth device on your Adastra Amplifier, first ensure that the volume controls are not turned down on the sending device. If the volume is up, check the volume and Play/Pause buttons in case Bluetooth is muted.
General| Inputs | RCA |
|---|---|
| Outputs | Binding Post |
| Power supply | 230Vac, 50Hz |
| Protection | Overload, short circuit |
| Frequency Response | 20Hz - 20kHz |
To Next Page
