AGLAS Master Control Device
Installation of stand-alone AGLAS Masters
© ADB SAFEGATE All Rights Reserved
16
96A0480 Rev. B
2.4.4 Safety Instructions
NOTE: The AGLAS Master is maintenance free.
The AGLAS Master may only be opened by authorized maintenance personnel.
DANGER
Work on the incoming power supply systems or the series circuit must only be
carried out by trained, qualified staff.
Follow the currently applicable regulations according to local and international
standards.
WARNING
When working on or carrying out measurements on the device, the following basic
rules must be followed:
• The device must be disconnected from the incoming power supply (isolated).
• The device must be secured against being accidentally switched on.
• Disconnection must be measured or checked.
The housing must not be opened until all electrical supply cables have been
disconnected for at least 5 minutes. When the housing is open, the incoming
power and the high voltage on the series circuit are exposed and freely accessible
at various locations. For this reason, work or measurements on the component
assemblies are only permitted when there is a second person in the room who will
be able to take appropriate action in the event of an accident.
Only potential-free instruments may be used for measurements on componentry.
• Components still carry hazardous or deadly voltages even after being switched
off.
• ESD susceptible devices (ESDS): Components susceptible to damage by
electrostatic discharges
• The component assemblies contain components that are susceptible to
electrostatic discharges. These components can be very easily destroyed if not
handled properly. However, if it is necessary to work on electronic assemblies,
follow the instructions below:
• Electronic assemblies should only be touched if working on them is absolutely
necessary.
• If assemblies have to be touched, the bodies of those working on them must be
discharged to ground immediately prior to contact.
• Connection pins and printed circuit conductors must not be touched.
Assemblies must only be held by the edge.
• Assemblies may not be brought into contact with highly insulating materials –
e.g. plastic parts, insulating table tops, or clothing made of artificial fibers.
• Assemblies may only be placed on conductive surfaces.
• Assemblies and components must only be stored or shipped in conductive
packaging (such as metallic or metallized plastic containers).
• If the packaging itself is not conductive, assemblies must be wrapped in a
conductive material before packing.
To Next Page
Loading...
Need help?
General