EasyManua.ls Logo

ADB AGLAS - AGLAS System Specifications Table

ADB AGLAS
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© ADB SAFEGATE All Rights Reserved
27
2.8 Technical Specifications
Table 2: AGLAS Specifications
Description Remote Master
Operating temperature -40 °C to +65 °C 0 °C to +55 °C
Storage temperature -55 °C to +85 °C -40 °C to +75 °C
Operating humidity Max. 100 % Max. 95 % non condensing
Series circuit operating voltage Max. 5000 V AC RMS
Min. / max. Power line current 1.8 up to 6.9 A RMS 1.8 up to 6.9 A RMS
Series circuit peak voltage Max. 15 kV
Maximum switching power secondary side
of transformer
300 W (single Remote)
Ch A + Ch B < 300 W (dual)
-
Maximum circuit load (CCR power) 30 kVA
Power consumption Max. 8 W at 6.6 A
Max. 15 W for power supply 115-230 V
Max. 65 W on primary circuit at 6.6 A
Enclosure protection level IP 68 / NEMA 6 P IP 20
LAN connection to upper control system IEEE 802.3 100 BaseT / IEEE1588 PTP
Net voltage of power supply 115 - 230 V AC ±15 %, 50/60 Hz
MTBF > 200.000 h > 200.000 h
Indicative MTTR < 30 min < 60 min
Lightning protection 20 kA (8/20 micro sec.) 17 kA (8/20 micro sec.)
EMC (CE approved)
Compliant to the EN 61000-6-4 (EMC emission standard) Compliant to the EN 61000-
6-2 and 6-5 (EMC immunity standard) Compliant to the 60950 (IT equipment
standard)
Power Up Mode On; Off; Flashing; Maintained (last commanded state)
Fail-Safe Mode On; Off; Flashing, Maintained (last commanded state)
Number of controlled and monitored
lamps per unit
1 or 2
Up to 300 Remotes or 600 lights, if dual
Remotes are used
Number of I/O Remotes per circuit Max. 16
Transmit Frequency 11 different frequency bands between 20 kHz and 200 kHz
Data transmission rate power line Up to 8 kbps Up to 8 kbps
Dimensions (W x H x D) / Weight
208 x 78 x 142 / 2,2 kg (single Remote)
/2,3 kg (dual)
435,8 x 177,5 x 421,5mm / 22,3 kg
Lamp failure reaction
Short is placed across isolation
transformer as soon as lamp filament
failure detected
Power Storage after Power-Off
Remote does not reset and remains in
operation, if circuit power loss < 1.5 sec.
Remote start up time is less than 1 sec.