© ADB SAFEGATE All Rights Reserved
96A0480 Rev. B
1
AGLAS Master Control Device
Safety
1.0 Safety
This section contains general safety instructions for installing and using ADB Airfield Solutions equipment. Some safety
instructions may not apply to the equipment in this manual. Task- and equipment-specific warnings are included in other sections
of this manual where appropriate.
1.1 HAZARD Icons used in the manual
For all HAZARD symbols in use, see the Safety section. All symbols must comply with ISO and ANSI standards.
Carefully read and observe all safety instructions in this manual, which alert you to safety hazards and conditions that may result
in personal injury, death or property and equipment damage and are accompanied by the symbol shown below.
1.1.1 Qualified Personnel
WARNING
• Failure to observe a warning may result in personal injury, death or equipment damage.
DANGER - RISK OF ELECTRICAL SHOCK OR ARC FLASH
• Disconnect equipment from line voltage. Failure to observe this warning may result in personal injury, death,
or equipment damage. ARC Flash may cause blindness, severe burns or death.
WARNING - WEAR PERSONAL PROTECTIVE EQUIPMENT
• Failure to observe may result in serious injury.
WARNING - DO NOT TOUCH
• Failure to observe this warning may result in personal injury, death, or equipment damage.
CAUTION
• Failure to observe a caution may result in equipment damage.
IMPORTANT INFORMATION
The term qualified personnel is defined here as individuals who thoroughly understand the equipment and its safe operation, maintenance and
repair. Qualified personnel are physically capable of performing the required tasks, familiar with all relevant safety rules and regulations and have
been trained to safely install, operate, maintain and repair the equipment. It is the responsibility of the company operating this equipment to
ensure that its personnel meet these requirements.
ALWAYS USE REQUIRED PERSONAL PROTECTIVE EQUIPMENT (PPE) AND
FOLLOW SAFE ELECTRICAL WORK PRACTICE.
To Next Page
Loading...