EasyManua.ls Logo

ADC EcoWash EWH-25 - Page 33

Default Icon
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MODEL 10,13,18,25 40,60,120
Unpack removing the bag and corner pieces Unpack: follow indications stuck on the package
Install water hoses (a filter is required in the cold water inlet) Install hoses (filter necessary in each inlet)
GENERAL
Leaving the door open when the washing machine is not running is recommended
Installing a 300 mA differential switch between the wiring and the mains is recommended
Put in the correct load (complete) and select the appropriate programme
Clean the outside of the machine with a damp cloth
At the end of the shift, clean the door seal with a damp cloth and turn the machine off
WASHING MACHINE PREVENTIVE MAINTENANCE
Connect drainage pipe. Important: ensure the correct inclination for full water disposal
Before turning the line breaker on measure voltage between phases and phase-neutral
WASHING MACHINE INSTALLATION AND MAINTENANCE
Fixing all low revolution washing machines to the floor is compulsory
Ensure that the dynamic pressure from the mains to the machine inlet is from 2 to 4 bars
Check that the specification plates correspond with the order
Fit out the machine location so that it is levelled and the necessary distances are observed for maintenance
POSITIONING
WASHING MACHINE INSTALLATION
Ensure that the floor withstands the weight and maximum force transmitted by the machine
Drain water circuits prior to making the connections
Connect the mains supply. Compare mains voltage and machine voltage (observe specification plate)
Remove the transport anchors
STEAM machines: - installing Teflon joints on both ends of the hose is compulsory
- installing a filter in the steam electrovalve inlet is compulsory
- always open the steam cock gradually and not suddenly
- retighten the steam hose nuts
It is advisable for the voltage between neutral and earth be equal to zero
Clean converter ventilation filter and motor fan grille
Check belt tension
THREE-MONTHLY
INSTALLATION
Fixing all high revolution washing machines to the floor is recommended
It is advisable that the floor is not slippery
DAILY
WEEKLY
Clean the water inlet filters
Clean the detergent tray compartments so that there are no blockages

Related product manuals