15
5.6. Selecting Measurement Mode (6022N, 6023N only)
This instrument enables you to select either standard (single
measurement) or measurement averaging mode (automatic triple
measurement).
To select Standard mode, push the switch on the sidea)
of the instrument towards position "1."
To select Averaging mode, push the switch toward position "3." b)
Note the MAM Advantage
™
Averaging mode icon will
illuminate on the display.
If you select 1, then only one measurement will be taken. If you
select 3, the unit will inflate and deflate three times resulting in
one final average.
5.7. Using MAM Advantage™ Averaging Mode (6022N,
6023N only)
In MAM Advantage
™
Averaging mode, three measurements are1.
automatically taken in succession and the result then
automatically analyzed and displayed. Because your blood
pressure constantly fluctuates, a result determined in this way is
more reliable than one produced by a single measurement.
After pressing the «ON/OFF» button, the MAM Advantage
™
2.
Averaging mode icon appears in the display.
The bottom right hand section of the display shows a 1, 2, or 3 to3.
indicate which of the 3 measurements is currently being taken.
There is a break of 15 seconds between the measurements (154.
seconds are adequate according to “Blood Pressure Monitoring,
2001, 6:145-147” for oscillometric instruments). A countdown
indicates the remaining time and a beep will sound 5 seconds
before the 2nd and 3rd readings will begin.
The individual results from measurements 1, 2 and 3 are not5.
initially displayed.
6
0
2
2
N
6
0
2
3
N
M
o
d
e
l
s
O
n
l
y
To Next Page