ADC ADS-75 User Manual

ADC Part No. 113035
For replacement parts, contact the distributor from which the dryer
was purchased or
American Dryer Corporation
88 Currant Road
Fall River MA 02720-4781
Telephone: (508) 678-9000 / Fax: (508) 678-9447
E-mail: techsupport@amdry.com
020698JEV/tf
WARNING: For your safety the
information in this manual must be
followed to minimize the risk of fire or
explosion or to prevent property damage,
personal injury or death.
Do not store or use gasoline or other flammable
vapor and liquids in the vicinity of this or any
other appliance.
WHAT DO YOU DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electrical switch; do not use
any phone in your building.
* Clear the room, building or area of all
occupants.
* Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
* If you cannot reach your gas supplier, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
AVERTISSEMENT: Assurez-vous de bien
suivre les instructions données dans cette
notice pour réduire au minimum le risque
dincendie ou dexplosion ou pour éviter tout
dommage matériel, toute blessure ou la mort.
Ne pas entreposer ni utiliser dessence ni
dautres vapeurs ou liquides inflammables dans
le voisinage de cet appareil ou de tout autre
appareil.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR
DE GAZ:
* Ne pas tenter dallumer dappareil.
* Ne touchez à aucun interrupteur. Ne pas
vous servir des téléphones se trouvant dans
le bâtiment où vous vous trouvez..
* Évacuez la pièce, le bâtiment ou la zone.
* Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions
du fournisseur.
* Si vous ne pouvez rejoindre le fournisseur
de gaz, appelez le service des incendies.
Linstallation et lentretien doivent être assurés
par un installateur ou un service dentretien
qualifié ou par le fournisseur de gaz.
AD-75
Installation/Operator’s Manual
(DSI Gas/Electric/Steam)

ADC ADS-75 Specifications

General

Brand	ADC
Model	ADS-75
Category	Dryer
Language	English

Summary

SECTION I IMPORTANT INFORMATION

A. RECEIVING and HANDLING

Procedures for inspecting and handling the dryer upon delivery to identify and report shipping damage.

B. SAFETY PRECAUTIONS

Critical safety warnings for handling flammables, gas leaks, installation, and operation.

SECTION II SPECIFICATIONS/COMPONENT IDENTIFICATION

A. SPECIFICATIONS

Detailed technical specifications for dryer capacity, dimensions, electrical, gas, and steam requirements.

B. COMPONENT IDENTIFICATION

Illustrates and labels key components visible on the front and rear of the dryer unit.

SECTION III INSTALLATION PROCEDURES

A. LOCATION REQUIREMENTS

Specifies necessary conditions and clearances for installing the dryer in a suitable location.

B. UNPACKING/SETTING UP

Instructions for safely removing the dryer from packaging and preparing it for installation.

C. DRYER ENCLOSURE REQUIREMENTS

Details specifications and clearances required for dryer enclosures, including wall and ceiling clearances.

D. FRESH AIR SUPPLY

Explains the importance and requirements for providing adequate fresh air (make-up air) for dryer operation.

E. EXHAUST REQUIREMENTS

General exhaust duct information, including sizing, installation, and venting requirements for safety.

F. ELECTRICAL INFORMATION

1. ELECTRICAL REQUIREMENTS

Essential requirements for electrical installation, emphasizing code compliance and use of qualified electricians.

2. ELECTRICAL SERVICE SPECIFICATIONS

Electrical service specs for gas/steam models: voltage, phase, amp draw, wire size, circuit breakers.

B. Electric Models Only ADE-75 (Electric)

Electrical service specifications specifically for the electric model ADE-75.

3. GROUNDING

Procedures for proper grounding of the dryer for safety and operational integrity.

4. ELECTRICAL CONNECTIONS

Details wiring connections for gas, steam, and electric models, including single-phase, 3-phase, and grounding.

G. GAS INFORMATION

1. GAS SUPPLY

Requirements for gas supply installation, emphasizing code compliance and qualified professionals.

2. TECHNICAL GAS DATA

Technical data for natural and L.P. gas: specifications, connections, and orifice sizes.

3. PIPING/CONNECTIONS

Guidelines for gas piping and connections, emphasizing code, regulators, and supply line sizing.

H. STEAM INFORMATION

1. Steam Coil PH Level

Specifies required PH levels for steam coils to prevent damage and maintain warranty.

2. Steam Requirements - High Pressure

Operating steam pressure requirements, heat input, and consumption for steam dryers.

3. Installation Instructions

Crucial installation instructions for steam supply/return lines to ensure proper operation.

I. PREPARATION FOR OPERATION/START-UP

J. PREOPERATIONAL TESTS

4. Make a complete operational check of ALL safety related circuits:

Ensures all safety circuits, including door switches, hi-limits, and sail switches, are functioning correctly.

K. PREOPERATIONAL INSTRUCTIONS

SECTION VI ROUTINE MAINTENANCE

A. CLEANING

Schedule and procedures for cleaning lint from the dryer, duct work, and surrounding areas for safety.

SECTION IV SERVICE/PARTS INFORMATION

A. SERVICE

Service must be performed by qualified technicians; contact distributor or ADC Service Department.

B. PARTS

Replacement parts should be purchased from the distributor or ADC factory; provide model and serial number.

SECTION V WARRANTY INFORMATION

A. RETURNING WARRANTY CARD(S)

Information on obtaining and returning the warranty card for customer service and claims.

B. PARTS

How to obtain a copy of the commercial warranty and warranty information from ADC.

C. RETURNING WARRANTY PARTS

Procedures for returning warranty parts, including obtaining prior written authorization (RMA).

SECTION IX TECHNICAL INFORMATION (DATA LABEL)

A. DATA LABEL

Details on the dryer data label providing essential information for service and parts.

SECTION X TROUBLESHOOTING

MICROPROCESSOR (COMPUTER) MODELS

Troubleshooting guide for microprocessor-controlled dryers, covering common issues and potential causes.

TIMER MODELS

Troubleshooting guide for timer-controlled dryers, covering common issues and potential causes.