17
Memory Function
Measured result obtained in "AUTO" mode is automatically saved
in the memory and can be recalled until next measurement is taken.
The result is not saved when the measurement is performed
in "MANUAL" mode.
To recall the result, turn on the device by pressing "I" side of
MAIN POWER SWITCH and set the device to "AUTO" with
MODE SELECTOR.
Press SET/MEMORY button and the last
result from "AUTO" measurement is displayed.
Turn off the device by pressing "O" side of MAIN POWER SWITCH.
The device will be in the energy saver mode after approximately
3 minutes if it is not turned off. See page 10.
To Next Page
Loading...
