19
Error Displays and Troubleshooting
ERROR SYMBOL/SYMPTOM CAUSE REMEDY
LOW BATTERY:
Battery is weak.
BATTERY ERROR:
Charge the battery.
The indication appearing
during LCD segment test,
which is performed when
the unit is turned on, does
not indicate low battery or
battery error.
ENERGY SAVER MODE:
The device was left turned
on and has not been oper-
ated for over approximately
3 minutes.
When the preset pressure
value was not high enough
to make measurement or
when noise was detected,
the cuff is pressurized
again to a higher level.
Patient moved during
measurement.
Patient is not being meas-
ured with correct posture.
Blood pressure readings
constantly vary with time
of measurement and physi-
cal and mental condition.
Patient moved during
measurement. There was
not enough rest taken
before measurement.
Change the battery. Only a
few measurements can be
made before the battery runs
down.
Charge the battery. Measure-
ment cannot be conducted.
Turn off the device or press
START/STOP button or
SET/MEMORY button to acti-
vate the device from energy
saving mode. Make sure to
turn off the device by press-
ing “
o” side of MAIN POWER
SWITCH after use.
This does not indicate a
problem.
Make sure that the patient
stays still and quiet during
measurement.
Make sure that the patient is
being measured with correct
posture.
Make sure that the patient
stays still during measure-
ment. Allow your patient to
rest for at least 5 minutes.
Measurement is inter-
rupted once and the cuff
is inflated again.
Blood pressure is differ-
ent each time. The read-
ing is extremely low (or
high)
Pulse rate is too low (or
too high).
To Next Page
Loading...
