9
Preparation for Use
Connecting and Using the AC Adapter (All models)
Connect AC ADAPTER PLUG to AC ADAPTER JACK
Plug AC ADAPTER in the power socket.
AC INDICATOR is lit when AC ADAPTER is connected correctly.
Installing the RECHARGEABLE NiMH Battery (All models)
NOTE: The battery enclosed in the product package is not charged, and needs to be
charged for about 4 hours before use.
NOTE: Turn off the power and unplug AC ADAPTER
before inserting the battery. Make sure " O " side
of MAIN POWER SWITCH is pressed down.
Remove BATTERY COMPARTMENT COVER by
loosening and removing the screw.
(Fig. 1)
Connect BATTERY PLUG to BATTERY
CONNECTOR inside the battery compartment
and insert the battery.
(Fig. 2)
Put back BATTERY COMPARTMENT COVER and
close it by inserting and tightening the screw.
Connect AC ADAPTER PLUG and plug AC
ADAPTER in the power socket to charge the
battery. The battery is charged regardless of whether
the e-sphyg
TM
2 is powered on or off.
Orange light of AC INDICATOR indicates that
the battery is being charged.
(Fig. 3)
The battery is fully charged after approximately 4 hours.
Unplug AC ADAPTER after the light turns
green as it indicates the battery is charged.
The color of the AC INDICATOR
may switch to green and return to
orange if the 9002 is operated
while charging battery, however it
does not indicate a problem.
(Fig. 1)
(Fig. 2)
(Fig. 3)
ADAPTER
PLUG
BATTERY PLUG
To Next Page
Loading...
