24
be locked directly, or if you do not operate the button for 1 minute, it will automatically return to the main display and lock
the screen. As shown in Figure 16, the sub display area displays the number of records. When the number exceeds the
display range of the sub display area, only the low digits of the record numbers are displayed.
2.7.2 OccupiedStorage Capacity
The title bar displays 2, and the main display area displays CAP, short press Enter button to view the occupied
storage capacity.
2.7.3 Interval Setting
The title bar displays 3, and the main display area displays GAP, short press Enter button to edit the logging interval,
range is from 1 s to 99999 s, or 0.1 s.
2.7.4 Clear Data
The title bar displays 4, and the main display area displaysdEL, short press Enter button to input password 1234, then
short press Enter to clear all recorded data.
2.8 Screen Lock and Unlock
Short press the Power button to lock and unlock the screen. When the screen is locked, a lock icon will be displayed
in status bar. Click other places on the screen, the lock icon will flash to remind the pressure gauge has entered the lock
screen status.
Note: If password protection is enabled, you will be prompted to enter the passwordto unlock, and only the correct
password can unlock the display.
2.9 Password Keyboard Display and Editing
The password keyboard will pop up when performing pressure gauge calibration, restore tofactory setting and clear
the data log. The password keyboard can edit each digit. Digit being edited will flash, short press Down button to switch
To Next Page
Loading...
