Additel ADT681A - Pressure Leak Test

20
Table 5Pressure peaks setting
Subject
Introductions
Max
Maximum Value
Min
Minimum Value
Zero
Reset data
2.6 Pressure Leak Test
1. In the main display, long press the Unit button to switch theitems in sub display area, and switch to
△
P. At this
moment, the sub display area displays the leak test time, and the main display area displays the pressure value.
Short press the Zero button to perform the pressure leak test, as shown in figure 12.The main display area displays
the real-time pressure value, and the sub display area displays the test time. When the leak test is running, short
pressing the Return button will stop the ongoing test and return to the main display.
Figure 12Leak test running