It is used to fine-tune the default angle of the servo, and can correct the angle error
generated when the servo is installed. When returning to the center, the rudder will
return to this default angle.
①
Enter the number of the PWM port connected to the servo you want to fine-tune in
the PWM input box.
②Click these two buttons to make the servo rotate slightly clockwise or
counterclockwise.
③
Click this button to save the current servo angle as the default angle.
④ Click this button to initialize the default angle of all servos to factory settings.
2.5.5 Home Module
HOME: Returning all servos to their initial positions.
2.5.6 Radar Scan Control Module
Used to perform the ultrasound scan function and display the scan results.
2.5.7 Ports Control Module
To Next Page
Loading...
