ADJ DMX OPERATOR 384 - Editing Chases

Deleting Chase Steps
Add a Chase Step
Press the Tap/Disp button, the Step indicator light should illuminate in the LED-
display.
Editing Chases
(1)
(2)
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display flashes. Once the indicator is flashing, record
mode is engaged and you may release the Program button.
(3)
(4)
(6)
Select the Chase # button, 1-12, that you wish to add a step to. The relevant
Chase LED should illuminate.
Press the Bank UP/DOWN buttons to manually step through the chase steps.
Find the chase step that you wish to add a step after.
Press the Tap/Disp button disengage Step mode. The Step indicator, in the LED-
display,should be OFF.
(5)
Using the BANK UP & DOWN buttons, select the scene bank, 1-30, that contains
the scene you want to add. You can view the scene banks in the LED-display by
referring to the furthest two digits to the right.
Press the Midi/Rec button the record the step into your chase. All LED s should
flash three times to confirm that the chase step was added.
(7)
Repeat steps 3 through 7 to add additional chase steps.
(8)
(9)
Press and hold down the Program button for approximately 2 seconds to exit. A
flashing Blackout indicator, in the LED-display, is indicative that you are out of
program mode.
(1)
Select the Chase # button, 1-12, that you want to delete a step in. The relevant
chase LED should illuminate.
(2)
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display stops flashing. A flashing Blackout indicator, in
the LED-display,is indicative that you are out of program mode.
(7)
(3)
Repeat steps 4 & 5 to delete additional chase steps.
(6)
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display flashes. Once the indicator is flashing, record
mode is engaged and you may release the Program button.
Press the Tap/Disp button, the Step indicator light should illuminate in the
LED-display.
(4)
Press the Bank UP/DOWN buttons to manually step through the chase steps.
Find the chase step that you want to delete.
Press the Auto/Del button to delete the chase step. All LED's should flash three
times to confirm that the chase step was deleted.
(5)
14
DMX OPERATOR 384